Click here to make tpub.com your Home Page

Page Title: REMOVING MOTOR/TAKE-UP CABLE ASSEMBLY
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 11-7025-217-30
REMOVING MOTOR/TAKE-UP CABLE ASSEMBLY
2-74.
Turn off power before working on
equipment. Failure to do so can cause
serious injury to personnel.
Set POWER ON/OFF circuit breaker to
1.
OFF.
Disconnect printer from power source.
2.
Remove logic board (para 2-64).
3.
NOTE
Connector P9(1) is not used. Note
its routing and location.
Loosen two screws (2), turning each screw
two turns at a time, until connector p5(3)
can be removed from connector J5(4).
Loosen two screws (5), turning each screw
5.
two turns at a time, until connector
P1O(6) can be removed from connector
J1O(7).
Remove cable assembly (8) from printer.
6.
INSTALLING MOTOR/TAKE-UP CABLE
2-75.
ASSEMBLY
Aline connector P1O(6) with connector
1.
J1O(7) and tighten two screws (5), two
turns at a time, until connector is tight.
2.
Aline connector P5(3) with connector
J5(4) and tighten two screws (2), two
turns at a time, until connector is tight.
NOTE
Connector P9(1 ) is not used. Route and locate as noted in
removal.
Install logic board (para 2-55).
2-119

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business