|
|
TM 11-7025-217-30
REMOVING POWER CABLE
2-72.
Turn off power before working on
equipment. Failure to do so can cause
serious injury to personnel.
1.
Set POWER ON/OFF circuit breaker to
OFF.
2.
Disconnect printer from power source,
3.
Remove logic board (para 2-54).
4.
Remove power control assembly (para
NOTE
In steps 5 and 6, make note of color-
coding on power cable leads before
removing.
Remove three nuts (1) and power cable
5.
(2) leads from stud terminals E2, E3, and
E4 (3) on power control assembly (4).
6.
Remove three nuts (5) and power cable
(2) leads from stud terminals E5, E6, and
E7 (6) from print system motherboard (7).
INSTALLING POWER CABLE
2-73.
Connect power cable (2) leads E5, E6, and
1.
E7 to corresponding stud terminals (6) on
print system motherboard (7). Apply
retaining compound (item 7, App B) to stud
terminals and install three nuts (5).
2. Connect power cable (2) leads E2, E3, and E4 to corresponding stud terminals (3) on power
control assembly (4). Apply retaining compound (item 7, App B) to stud terminals and install
three nuts (1).
3. Install power control assembly (para 2-67).
4. Install logic board (para 2-55).
2-118
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |