|
|
TM 11-7025-217-30
2-66. REMOVING POWER SUPPLY
Turn off power before working on
equipment. Failure to do so can cause
serious injury to personnel.
1. Set POWER ON/OFF circuit breaker to
OFF.
2. Disconnect printer from power source.
3. separate chassis (para 2-30).
NOTE
Perform steps 4 thru 9 to remove only
converter assembly.
4.
Loosen two screws (1), turning each
screw two turns at a time, until con-
nector P7(2) can be removed from
connector J7(3).
Loosen two screws (4), turning each screw
5.
two turns at a time, until harness con-
nector P6(5) can be removed from
connector J6(6).
Loosen two screws (7), turning each
6.
screw two turns at a time, until con-
nector P4(8) can be removed from
connector J4(9).
7. Loosen wedgelock screw (10) on each
side of converter assembly (11).
Remove three screws, Iockwashers, and
8.
flatwashers (12) from Power supply
chassis (13).
9. Carefully pull converter assembly (11)
from power supply chassis (13).
NOTE
Perform steps 10 thru 16 to remove only
power control assembly.
2-109
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |