|
|
TM 11-7025-217-30
2-30. SEPARATING CHASSIS
Turn off power before working on equipment. Failure to do so
can cause serious injury to personnel.
NOTE
Ensure printer door is closed, and captive thumbscrews are tight.
Set POWER ON/OF F circuit breaker
1.
to OFF.
2.
Disconnect printer from power source.
Disconnect input power cable from
3.
connector J 1 ( 1 ) and 1/0 cable from
connector J2(2).
Position printer on its side.
4.
Remove two bottom screws (3) and two
5.
flatwashers (4).
Position printer upright and remove two
6.
top screws (5) and two flatwashers (6).
CAUTION
Use care when separating chassis to avoid damaging harness and
cable assemblies.
7. Carefully separate power supply chassis (7) from printer chassis (8).
2-73
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |