|
|
TM 11-7025-217-30
2-67. INSTALLING POWER SUPPLY
NOTE
Perform steps 1 thru 6 if only
converter assembly was previously
removed.
1. Slide converter assembly (1) into power
supply housing (2).
Install three screws, Iockwashers; and
2.
flatwashers (3) into power supplY
housing (2) to secure converter
assembly (1).
3. Tighten wedgelock screw (4) on each side
of converter assembly (1).
4. Aline connector P6(5) to connector J6(6)
and tighten two screws (7), two turns at
a time, until connector is tight.
5. A line connector P7(8) with connector
J7(9) and tighten two screws (10), two
turns at a time, until connector is tight.
6. Aline connector P4 (11) with connector
J4(12) and tighten two screws (13), two
turns at a time, until connector is tight.
2-111
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |