|
|
TM 11-7025-217-30
NOTE
Perform steps 7 thru 13 if only
power control assembly was pre-
viously removed.
7.
Install power cable on power control
assembly (para 2-73).
8. Slide power control assembly (14) into
power supply housing (2).
9.
Install three screws, Iockwashers, and
flatwashers (15) into power supply
housing (2) to secure power control
assembly (14).
10. Tighten wedgelock screw (16) on each
side of power control assembly (14).
11. Aline connector P8(17) with connector
J8(18) and tighten two screws (19), two
turns at a time, until connector is tight.
12. Aline and mate connector P3(20) to
connector J3(21 ). Close two retaining
arms (22) to secure connectors.
13. Aline connector P5(23) with connector
J5(24) and tighten two screws (25), two
turns at a time, until connector is tight.
2-112
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |