|
|
TM 11-7025-217-30
7. Install connector J10(10) and two nuts (11)
on mounting bracket (4).
8. Aline connector P10(12) with connector
J10(10) and tighten two screws (13), two
turns at a time, until tight.
NOTE
Remove any excess slack in harness in
door and under motherboard.
9. Install loop clamp (14), loop washer (15),
flatwasher (16), and screw (17).
10. Install logic board (para 2-55).
11. Join chassis (para 2-31).
12. Close door (18) and tighten two captive
thumbscrews (19).
2-107
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |