|
|
TM 11-7025-217-30
INSTALLING MOTOR HARNESS ASSEMBLY
2-63.
Route harness (1) in door (2) and under
1.
print system motherboard (3) to the
J10 mounting bracket (4) as noted
during removal.
2. Aline connector P11(5) with
connector J 11 (6) and tighten two
screws (7), two turns as a time, until
connector is tight.
3.
Install harness tie (8) in position noted
during removal.
4. Strip and tin ends of harness (1)
wires.
5. Slide heat shrinkable tubing (item 8,
Appx B) (9), over ends of wires on
harness (1).
Solder wires of harness (1) to pins on
6.
connector J10(10) as tagged. Slide
heat shrinkable tubing over solder
joints and apply heat. Remove tags.
2-106
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |