|
|
TM 11-7025-217-30
7. Loosen two captive thumbscrews(11) and open door (12).
8. Loosen no screws (13), turning each screw two turns at a time, until connector P11(14) can be
removed from connector J11 (15).
9. Remove harness tie (16). Note position of tie so that it goes back in the right place.
NOTE
Note the way harness is routed in door and under
motherboard before it is removed.
10. Carefully pull harness (6) from under print system motherboard (17) and out of chassis (18).
2-105
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |