|
|
TM 11-7025-217-30
INSTALLING STEPPER MOTOR AND DOOR HARNESS ASSEMBLY
2-53.
1.
Install drive spur (1) on shaft (2) and tighten setscrew (3).
2. Aline motor mount (4) with motor (5) and install three screws (6).
3. Aline motor (5) with mounting holes on door (7).
4. Put drive belt (8) over drive spur (1).
Route wires (9) under motor mount (4).
5.
Install two screws (10), using care not to pinch wires (9).
6.
7.
install wires (9), as tagged, using two screws(11) and two flatwashers (12). Remove tags.
Route harness (13), as shown, and aline
8.
connector J11 (14) with mounting holes
on door (7).
Install two screws (15).
9.
10. A line harness connector P11 (16) with con-
nector J11 ( 14) and tighten two screws
(17), turning each screw two turns at a
time, until tight.
11.
Install harness tie (18) around motor (5).
12.
Install guide roller assembly (para 2-49).
Install drive roller assembly (para 2-47).
13.
14.
Install spring loaded roller assembly (para 2-45)
2-93
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |