|
|
TM 11-7025-217-30
NOTE
If shaft is replaced, install screw
at one end of replacement
shaft before using.
4. Slide shaft (6) through mounting
hole on door (7).
5. Slide bushing (8) and left tension
spring (9) on shaft (6), inserting straight
end of left tension spring under hold-
down (10) as shown. Rotate hooked
end of left tension spring (9) 1/4-turn
in the direction shown.
6. Hold back hooked end of left tension
spring (9) and slide roller frame
assembly (2) onto shaft (6).
7. Insert hooked end of left tension
spring (9) into mounting hole on roller
frame assembly (2).
USE OR DISCLOSURE OF THIS DATA IS SUBJECT TO THE RESTRICTION ON PAGE D OF THIS DOCUMENT.
2-86
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |