|
|
TM 11-7025-217-30
NOTE
Item 11 is not used in all
8. Continue sliding shaft (6) through
roller frame (2) and slide bushings (10)
and (11 ) onto shaft.
9.
Slide right tension spring (12) under drive
belt (13) and over bushings (9) and (11)
as shown.
10.
Insert hooked end of right tension spring
(12) in mounting hole on roller frame
assembly (2).
11.
Rotate straight end of right tension spring
(12), as shown, until spring can be
installed against inside frame of door (7).
Aline shaft (6) with mounting hole
12.
on door (7) and install screw (13).
13.
Close door (7) and tighten two
captive thumbscrews (14).
USE OR DISCLOSURE OF THIS DATA IS SUSJECT TO THE RESTRICTION ON PAGE D OF THIS DOCUMENT.
2-87
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |