Section I. REPAIR PARTS, SPECIAL TOOLS AND SUPPORT EQUIPMENT

TM 11-5805 -387-20-2

Section I. REPAIR PARTS, SPECIAL TOOLS AND SUPPORT EQUIPMENT

2-1. TOOLS AND TEST EQUIPMENT

Tools and test equipment required for organizational maintenance of the modem are listed in the

maintenance allocation chart (MAC) in appendix B of this manual.

2-2. SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT

There are no special tools or TMDE required for organizational maintenance of this equipment.

Refer to Organizational Maintenance Repair Parts and Special Tools (RPSTL) manual TM,

TM 11-5805-387-20P-1.

Section II. SERVICE UPON RECEIPT

NOTE

Do not unpack modem until you unpack, assemble, install and connect the

rack in which it is to be placed.

2-3. UNPACKING THE MODEM

ITEM

REMARKS

ACTION

1. Carton

Open

Unpack

See figure 2-1.

2. M o d e m

Report any damage on SF 364 Report of

Inspect for damage

done during shipment.

Discrepancy (ROD).

Be sure shipment is complete. Report any

C o m p a r e with packing

list.

differences according to instructions in

DA PAM 738-750.

Check for modifications.

Check on front panel near nomenclature plate

for any modification work order (MWO)

numbers. They will appear only if the unit

has been used or reconditioned. Current

MWO's which apply to the modem are listed

in DA Pam 310-1. Apply all URGENT

MWO's. Schedule all NORMAL MWO's.

2-4. INSTALLATION INSTRUCTIONS

CAUTION

Choose an installation space for the modem where adequate ventilation

is provided for transistor heat dissipation. Do not install unit close to other

heat-producing equipment, such as power units and space heaters. Ex-

cessive heat will damage the modem.

a. Tools, Test Equipment and Materials Needed for Installation

q All tools you will need to install the modem are in Tool Kit, Electronic Equipment

TK-101/G.

2-1