REMOVE/REPLACE CARRIAGE SERVO DRIVE BOARD (T3SD/1)

TM 11-7025-233-23

4-36. REMOVE/REPLACE CARRIAGE SERVO DRIVE BOARD (T3SD/1)

INITIAL SETUP

Materials/Spare Parts

Common Tools

q Tool kit

q Tie wraps

Remove

1. Access printer (para 4-11).

2. Disconnect cable connectors from

upper left and right edges of the

carriage servo drive board.

3. Cut tie wrap.

Pull cable away from

board.

CAUTION

Board must not be Separated from

heat sink to which it is attached.

Take care to remove correct screws.

(Do not remove screws on board).

4. Insert screwdriver through holes in

board. Remove screws and washers.

5. Remove board from printer.

4-91