|
|
TM 11-7025-217-30
2-26. REMOVING TOP COVER
Turn off power before working on equipment. Failure to do
so can cause serious injury to personnel.
1. Set POWER ON/OFF circuit breaker
(1) to OFF.
2. Disconnect printer from power source.
3. Remove three screws (2).
4. Remove one screw (3) and washer (4).
5.
Remove cover (5).
INSTALLING TOP COVER
2-27.
1.
Aline holes in top cover (5) with
mounting holes on chassis (6).
2.
Install three screws (2) and one screw
(3) and washer (4).
PRINTHEAD PRESSURE TEST
2-28.
1.
Set POWER ON/OFF circuit breaker
(1) to OFF.
2.
Disconnect printer from power source.
3.
Remove paper and spool. (Refer to
TM 11-7021 -201-12.)
CAUTION
Handle pressure test tool by its rein-
forcement tab. Body oil from fingertips
can cause tool to slip, giving incorrect
reading on dial pressure gage.
4,
Clean, pressure test tool with isopropyl
alcohol (item 1, Appx B) before use.
5.
Working from right end of printhead (2),
slide pressure, test tool (3) between
roller (4) and printhead (2).
2-70
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |