|
|
TM 11-7025-217-30
4.
Remove paper supply. (Refer to
TM 11-7021 -201-12.)
CAUTION
When cleaning printhead, do not
brush upward between print fingers.
Damage to printhead will result.
5.
Using printhead cleaning brush, lightly
brush across top of printhead above print
fingers to remove loose paper residue.
6.
Using printhead cleaning brush, lightly
brush downward to remove residue
between print fingers. Continue
downward brushing until all print fingers
on printhead have been brushed.
7.
After cleaning, inspect printhead with
magnifier to ensure all residue has been
removed.
8.
Repeat steps 6 and 7 until printhead is
clean.
9.
Use soft bristle brush to clean the loosened
residue out of the door assembly (3).
10.
Install paper supply. (Refer to TM 11-7021 -201-12.)
11.
Close door (3) and tighten two captive thumbscrews (2).
Perform printer self test. (Refer to TM 11-7021 -201-12.)
12.
2-25.
INSPECTION
Turn off power before working on
equipment, Failure to do so can
cause serious injury to personnel.
Set POWER ON/OFF circuit
1,
breaker (1) to OFF.
2.
Disconnect printer from power
source.
3.
Loosen two captive thumbscrews
(2) and open door (3).
4.
Remove paper supply.
(Refer to
TM 11-7021 -201-12.)
2-68
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |