Explanation of Columns (Section IV)

TM 11-5815-334-20P-1

Recoverability

Code

Application/Explanation

Z--Nonreparable Item. When unserviceable, condemn and dispose of the item at the category of maintenance

shown in the third position of SMR Code.

O--Reparable item. When uneconomically reparable, condemn and dispose of the item at organizational or aviation

unit category.

F--Reparable item. When uneconomically reparable, condemn and dispose of the item at direct support or aviation

intermediate category.

H--Reparable item. When uneconomically reparable, condemn and dispose of the item at general support category.

D--Reparable item. When beyond lower category repair capability, return to depot. Condemnation and diposal

of item not authorized below depot category.

L--Reparable item. Condemnation and disposal not authorized below specialized repair activity (SRA).

A--Item requires special handling or condemnation procedures because of specific reasons (e.g., precious metal

content, high dollar value, critical material, or hazardous material). Refer to appropriate manuals/directives

for specific instructions.

c. FSCM (Column (3)). The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code which

is used to identify the manufacturer, distributor, or Government agency, etc., that supplies the item.

d. Part Number (Column (4)). Indicates the primary number used by the manufacturer (individual, company,

firm, corporation, or Government activity), which controls the design and characteristics of the item by means

of its engineering drawings, specifications, standards, and inspection requirements to identify an item or range

of items.

NOTE

When you use a NSN to requisition an item, the item you receive may have a different

part number from the part ordered.

e. Description and Usable on Code (UOC) (Column (5)). This column includes the following information.

(1) The Federal item name and, when required, a minimum description to identify the item.

(2) Usable on code, when applicable (para 5).

(3) The statement "END OF FIGURE" appears just below the last item description in Column (5) for a

given figure in both section II and section III.

f. Qty (Column (6)). Indicates the quantity of the item used in the breakout shown on the illustration figure,

which is prepared for a functional group, subfunctional group, or an assembly. A "V" appearing in this column

in lieu of a quantity indicates that the quantity is variable and the quantity may vary from application to application.

4. Explanation of Columns (Section IV)

a. National Stock Number (NSN) Index.

(1) Stock number column. This column lists the NSN by National item identification number (NIIN) sequence.

The NIIN consists of the last nine digits of the NSN. When using this column to locate an item, ignore the first

four digits of the NSN. When requisitioning items use the complete NSN (13 digits).

(2) Fig. column. This column lists the number of the figure where the item is identified/located. The illus-

trations are in numerical sequence in sections II and III.

(3) Item column. The item number identifies the item associated with the figure listed in the adjacent Fig.

column. This item is also identified by the NSN listed on the same line.

b. Part Number Index. Part numbers in this index are listed by part number in ascending alphameric sequence.

(1) FSCM column. This column lists the Federal supply code for manufacturer (FSCM).

(2) Part number column. This column indicates the part number assigned to the item.

(3) Stock number column. This column lists the National stock number for the associated part number and

manufacturer identified in the part number and FSCM columns to the left.

(4) Fig. column. This column lists the number of the figure where the item is identified/located in sections

II and III.

(5) Item column. The item number is that number assigned to the item as it appears in the figure referenced

in the adjacent figure number column.