|
|
TM 11-5815-238-20
Gear set for 600 opm (100 wpm) operation is mounted on the gearcase cover at right to reperforator.
NOTE
If operation at 404 opm (66 wpm) or 460 opm (75 wpm) is desired, order through normal supply
channels.
NOTE
Gears are identified by stamped markings.
b. If It becomes necessary to change gear set, upon direction from supervisory personnel (SOP's etc.) do the
following:
CAUTION
Make certain MOTOR switch is OFF and power plug is removed from ac outlet.
Remove the tape reel.
Loosen the motor.
Remove the worm gear from the shaft of motor armature.
Remove the driven gear from the power shaft (use a gear puller).
Install worm gear* on the shaft of the motor armature.
Install driven gear* on the power shaft.
Reinstall motor.
Reinstall tape reel.
*matched set
2-8
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |