ADJUSTMENT PROCEDURES

TM 11-5805-387-34-2

FILTERS FL6, FL7

REMOVE

On the top side of the chassis remove two hex nuts holding filter to chassis.

Tag, unsolder and remove leads from terminals.

Lift out filter.

REPLACE

Place new filter into position.

Tighten two hex nuts.

Solder leads to filter terminals.

RELAY K1

REMOVE

Tag, unsolder and remove all wires from relay.

Remove 2 captive screws holding relay to compartment housing.

Remove relay.

REPLACE

Position relay on compartment housing.

Replace captive screws.

Solder wires to relay terminals.

3-10. ADJUSTMENT PROCEDURES

General support adjustment procedures are the same as direct support procedures. Refer to chapter 2, section IV.

3-25/(3-26 blank)