Section I: INTRODUCTION

TM 11-5815-306-34P

SECTION I

INTRODUCTION

1. Scope

NOTE

This manual lists spares and repair parts; special tools;

Cannibalization or salvage may be used

special test, measurement, and diagnostic equipment

as a source of supply for any items

(TMDE), and other special support equipment required

source coded above except those coded

for performance of direct sup- port and general support

XA and aircraft support items as

maintenance of the AN/FGC-80.

It authorizes the

restricted by AR 700-42.

requisitioning and issue of spares and repair parts as

(2) Maintenance code. Maintenance codes are

indicated by the source and maintenance codes.

assigned to indicate the levels of maintenance

2. General

authorized to USE and REPAIR support items. The

This Repair Parts and Special Tools List is divided into

maintenance codes are entered in the third and fourth

the following sections:

positions of the Uniform SMR Code format as follows:

a. Section II. Repair Parts List. A list of spares and

(a) The maintenance code entered in the third

repair parts authorized for use in the performance of

position will indicate the lowest maintenance level

maintenance. The list also includes parts which must be

authorized to remove, replace, and use the support item.

removed for replacement of the authorized parts. Parts

The maintenance code entered in the third position will

lists are composed' of functional groups in numeric

indicate one of the following levels of maintenance:

sequence, with the parts in each group listed in figure

and item number sequence.

Code

Application/Explanation

b. Section III. Special Tools List. Not applicable.

O - Support item is removed, replaced, used at the

c. Section IV. National Stock Number and Part

organizational level.

Number Index. A list, in National item identification

F - Support item is removed, replaced, used at the direct

number (NIIN) sequence, of all National stock numbers

support level.

(NSN) appearing in the listings, followed by a list, in

H - Support item is removed, replaced, used at the

alphanumeric sequence, of all part numbers appearing in

general support level.

the listings. National stock numbers and part numbers

(b) The maintenance code entered in the fourth

are cross-referenced to each illustration figure and item

position indicates whether the item is to be repaired and

number appearance.

identifies the lowest maintenance level with the capability

3. Explanation of Columns

to perform complete repair (i.e., all authorized

a. Illustration. This column is divided as follows:

maintenance functions). This position will contain one of

(1) Figure number. Indicates the figure number of

the following maintenance codes:

the illustration on which the item is shown.

(2) Item number. The number used to identify item

Code

Application/Explanation

called out in the illustration.

F - The lowest maintenance level capable of complete

b. Source, Maintenance, and Recoverability (SMR)

repair of the support item is the direct support level.

Codes.

H - The lowest maintenance level capable of complete

(1) Source code.

Source codes indicate the

repair of the support item is the general support

manner of acquiring support items for maintenance,

level.

repair, or overhaul of end items. Source codes are

Z - Nonreparable. No repair is authorized.

entered in the first and second positions of the Uniform

SMR Code format as follows:

(3) Recoverability code. Recoverability codes are

assigned to support items to indicate the disposition

Code

Definition

action on unserviceable items. The recoverability code is

PA - Item procured and stocked for anticipated or known

entered in the fifth position of the Uniform SMR Code

usage.

format as follows:

XD - A support item that is not stocked. When required,

item will be procured through normal supply

Recoverability

channels.

codes

Definition

Z - Nonreparable item. When unserviceable, condemn

and dispose at the level indicated in position 3.