Quantcast SIGNAL CIRCUIT CONNECTIONS FOR TT-699(*)IGGC

 

Click here to make tpub.com your Home Page

Page Title: SIGNAL CIRCUIT CONNECTIONS FOR TT-699(*)IGGC
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Share on Google+Share on FacebookShare on LinkedInShare on TwitterShare on DiggShare on Stumble Upon
Back
SEND ONLY AND LOCAL PREPARATION OF TAPE (cont)
Up
TM-11-5815-238-20 Teletypewriter Sets AN/GGC-3 AN/GGC-3A AN/GGC-53 AN/GGC-53A and Teletypewriter Reperforator-Transmitters TT-76/GCC TT-76A/GGC Manual
Next
DUPLEX OPERATION
TM 11-5815-238-20
2-11. SIGNAL CIRCUIT CONNECTIONS FOR TT-699(*)IGGC
Teletypewriter Set AN/GGC-53(*) or Teletypewriter Reperforator-Transmitter TT-699(*)IGGC does not need an
external power source.
Signal circuits within reperforator-transmitter are controlled by a SELECTOR switch located to right of keyboard.
Signal circuits of transmitter-distributor, keyboard transmitter and reperforator can be connected to external signal lines
at terminals 5, 6, 8 and 9-of A1TB-1. This permits reperforator-transmitter to operate in various sending and receiving
operations.
a. WIRING
Teletypewriter Reperforator-Transmitter TT-699(*)/GGC can only perform with a 6 volt polar operation; no
internal wiring changes are required.
b. INSTALLATION CONNECTIONS
For all polar operations, make sure line connections are the same as those shown below.
2-13

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc.