Section III. INSTALLATION INSTRUCTIONS

TM 11-5815-238-20

Section III. INSTALLATION INSTRUCTIONS

2-6. COMPONENT ASSEMBLY

Teletypewriter Set ANIGGC-3(*)

Place TT-76/GGC and table FN-52/GGC, on which it is mounted, on a flat surface. Lift front of FN-52/GGC until it is

almost upright.

Screw four table legs into leg. mounts on underside of table top.

Press chad bin into holder under table and secure it with the wire retainer.

To install paper tape and inking ribbon, refer to Operator's Manual TM 11-5815-238-10.

Teletypewriter Reperforator-Transmitter TT-76(*)IGGC

Use paper template (or wooden shipping base of TT-76IGGC) and mark top surface of table or shelf to be used to

support unit.

NOTE:

ALL DIMENSIONS ARE IN INCHES

Cut openings in table or shelf for tape storage guide, chad tube, mounting bolts and chad bin mounting brackets.

Secure TT-76(*)/GGC to table or shelf with suitable mounting bolts. Install tape guide tape storage bin (TT-761GGC

only) and chad tube retainer with hardware provided.

To install paper tape and inking ribbon, refer to Operator's Manual TM 11-5815-238-10.

2-5