Chapter 2. INSTALLATION

TM 11-5815-206-12/ TO 31W4-2PGC1-61

CHAPTER 2

INSTALLATION

NOTE

The procedures described in this chapter should be performed by qualified

teletypewriter maintenance personnel.

Section I. SERVICE UPON RECEIPT OF EQUIPMENT

2-1. Unpacking

and remove the lid of all models, except the TT-

537/G. On the TT-537/G, cut the tape and open

the triple-wall fiberboard carton.

a. Packaging Data. The factory packaging

(3) Carefully turn the wooden box or triple-

arrangement of the teletypewriter set is suitable

wall carton until the opening is down and lift the

for either export or domestic shipment. The

wooden box or triple-wall carton from the fiber-

wooden box is 20 inches high, 26 inches wide,

board carton.

and 26 inches deep. The volume of the wooden

(4) Carefully cut open one end of the fiber-

box is 9.5 cubic feet and the total weight of the

board carton and remove the Case CY-694(*)/PGC-

packaged set is approximately 200 pounds. When

only Teletypewriter TT-4(*)/TG, TT-335/TG, or

(5) If the equipment consists of the complete

TT-698(*)/TG is furnished, packaging is the same,

teletypewriter set, remove the technical manuals

except that Bag CW-356/U and the three cable

and accessories bag from the case. If only the TT-

assemblies (para 5a) are not included. When the

4(*)/TG, TT-335/TG, or TT-698/TG, is furnished,

TT-537/G is furnished, the wooden box is replaced

remove the technical manuals and the spare parts

with a triple-wall fiberboard carton and the ac-

package. For the TT-537/G, remove the technical

cessories bag (fig. 1-6) with the line cable assembly

manuals and accessories bag.

is included.

(6) Unfasten the six latches on the top of the

b. Removing Contents.

case, t i l t the lid upward, and remove the

(1) Cut the steel straps with a pair of tin

teletypewriter.

snips or other appropriate tool.

(2) Remove the nails from the wooden box lid

2-1