Mounting Procedure

TM 11-5805-387-20-2

b. Mounting Procedure

. The modem is designed to be used as part of a system, so determine correct installation

of the unit by its end use.

The modem may be installed on a separate mounting base.

. The modem may be stack-mounted with other units of similar case construction. For stack-

mounting installation, the modem is equipped with four round indentations.

c. Connections

CAUTION

Avoid transistor damage by always setting power switch to OFF before

making cable connections. Check polarity and measure voltage load of

power source before making connections. Transistors may be permanently

damaged by improper voltage or polarity.

Make all necessary external connections to modem at bottom of front panel as determined

by system requirements.

NOTE

No connection cables are supplied with modem; you must supply all cables

needed for specific connections. See figure 2-2 for detailed information

regarding connection of modem in typical equipment configurations.

2-3